Skip Navigation Website Accessibility
  601-630-3303
 
 


Kreinik Metallics - 021C Copper Cord 50m

Kreinik Metallics - Copper Cord 50m

Use Kreinik Blending Filament, by itself or combined with other yarns, to create random highlighting effect in all hand embroidery like cross stitch and needlepoint, plus machine embroidery, crochet, and knitting.

Kreinik Blending Filament is hand or machine washable and dry cleanable. Cool water is recommended. Do not use bleach. It can also be tumble-dried on low setting. When ironing a finished piece containing Blending Filament, do not iron directly on the thread; use a cloth, and do not use steam.

Tips on using Kreinik Blending Filament in hand work: 
Blending Filament comes on a snap-spool mechanism. Both sides of the spool open, so look for the side where the thread end is located. Insert your thumbnail under the cap, and rotate the spool while gently lifting the cap to release the thread (the cap should not pop off). Snap the lid shut to secure the unused portion.

Use short lengths of thread-about 45cm (18 inches) or less-to avoid excessive abrasion when pulling the thread through the ground fabric or canvas. The more a strand is pulled through fabric or canvas, the more 'wear' it causes on the thread. Using shorter lengths will maintain the quality of the thread, plus reduce tangling as shorter lengths are easier to control (less knotting!). If you are stitching on fabric, use a needle large enough to 'open' the hole in the fabric sufficiently and allow the thread(s) to go through more easily; this reduces friction and fraying.

If combining Blending Filament with another thread type in a needle, you may wish to moisten the filament together with the other thread with a slightly damp, soft cosmetic sponge. This can help to control both thread types as they work together in your needle.

Stitch slowly with Blending Filament to achieve more control and insure uniformity in stitching.

Let your needle hang frequently to let the thread untwist and thus reduce knotting.